<strong>SLK1200: 40m cable, suitable for areas up to 8.0m², </strong>1200W, 5.0A, 30W/lm², approx. cost = $50/m²

RRP $403.70

SKU: SLK1200 Category:

Product Description

In Slab Heat Kit 1200W X 40m

Thermostatic comfort control

Complete comfort control is easily achieved with the addition of optional manual or programmable thermostats available through Coldbuster.

Automated operation enhances the energy efficiency of the Coldbuster cable heating system. Programs can be set to regulate comfort levels via floor or room air temperature, up to 4 cycles per day, accommodating different weekday and weekend routines.

Unobtrusive and safe

Coldbuster in-screed and in-slab cable can be installed directly to concrete re-inforcing or secured to a metal ‘fixing rail’ for in-screed application. Coldbuster in-screed cable is suitable for the majority of floor finishes. The heater is waterproof, fully earthed and needs to be connected to a RCD circuit at the time of installation to ensure full protection against fire and shock hazards.

Multi application heating system

Following the recommended layout provided, unroll the heater strip and fix to mesh or rails. Care must be taken to never cross over elements.

The various ways to fix the cable in position include;

In-Slab application – The cable is tied to the reinforcing mesh
In-Screed application -Clip cables on to the metal fixing rails, which are nailed to the slab.
In-Screed on waterproofing, tie cable to reinforcing mesh or secure cable with duct tape. (Metal fixing rails can be used if glued onto the waterproofing)


Coldbuster tile heating is classified as an appliance and can be installed by any competent person. The heater must be connected to a RCD (safety switch) protected circuit by an electrician. All wiring must conform to AS/NZS 3000:2000 and local wiring regulations.

Service & support

Coldbuster provide a free design service and planning advice for your complete room heater layout. We are available to answer your questions relating to electrical preparation or installation of your floor heating system. If you prefer to leave the installation to a floor heating contractor, a professional design & installation service is available across Australia.

Robust Screed and Slab heating cable

Coldbuster screed heating cable comes in 8 different lenghts. A combination of these lengths caters for all room sizes e.g. from small bathrooms to large halls and acts as the primary or secondary heating source.The screed heating cable features;

  • Bi-directional, single ended 6mm cable is rated at 14W/m and is supplied as a cable on a roll.
  • Factory terminated 2.4 metre ‘cold tail’ power lead on heater
  • Installation guideline and personalised floorplan layout
  • Technical & installation support (telephonic)
  • Can be supplied as a kit including installation monitor, programmable thermostat and metal fixing rail

Additional Information

Weight 4 kg


There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Pin It on Pinterest