Under floor heating kit (8m² - 9m² room)

... Price: AU$551.00 .....Product Code: 760W-R

Availability

Usually ships in:

Coldbuster under floor heating features

Pre-configured element mounted on self adhesive tape
Factory terminated cold tail leads
1mm thin heating element which does not affect floor levels
Element & cold tail connections fully earthed & waterproof
Durable & reliable
Easy floor heating installation, no special tools required
5 Year guarantee

Easy installation process

Coldbuster under floor tile heating can be installed on a suspended timber or concrete subfloor for use under most hard surfaces throughout any home or commercial project.

Stick the Coldbuster under floor heater to the floor (floor heating insulation board, tile backer board or concrete) with the self-adhesive tape already positioned on the heater
Roll out and stick the self-adhesive fibreglass mesh over the heater
Connect the Klimaguard installation monitor to the factory terminated cold tails and you are ready to begin tiling

Coldbuster tile heating is classified as an appliance and can be installed by any competent person. The heater must be connected to a RCD (safety switch) protected circuit by an electrician. All wiring must conform to AS/NZS 3000:2000 and local wiring regulations.

Complete control and efficient energy use

Complete control and efficient energy use is ensured with the standard programmable thermostat supplied with each under floor heating kit.

Estimated floor heating running costs for a room using the 760W tile heater kit (a heated floor area between 8m² up to 9m²) is 4.6c per running hour (based on 15c per kW/h & a duty cycle of 40%).

Coldbuster 1210W kit contents

Pre-measured element mounted on self adhesive tape strip heater measures L7260mm x W600mm - average distance of 600mm-700mm from all walls equates to 50-60% of actual floor area
Factory terminated cold tail leads on the heater L2400mm
Self adhesive fibreglass mesh
Programmable thermostat control L125mm x W90mm x D30mm
Floor probe sensor L6000mm
Klimaguard installation monitor (element alarm/tester)
Installation guidelines
Technical & installation support (telephonic)

No additional supplies are needed other than bonding supplies normally used when laying a tile floor. We recommend the floor is primed prior to heater being layed.